When China twisting machine manufacturer installs and debugs, how to operate it is better. As a manufacturer of glass fiber equipment, let us know how to operate China twisting machine manufacturer after installation and debugging!

1. Before power supply, check whether the power terminal in the control box is locked.

2. Check whether parts of China twisting machine manufacturer are damaged or loose during handling.

3. Remove the take-up shaft movable top center and nut.

4. Check whether all transmission mechanisms of China twisting machine manufacturer are smooth during inching operation with foot switch.

When the foot switch is used for threading, the operator clicks the foot switch to make the China twisting machine manufacturer run at low speed (about 100m/min). In case of abnormal conditions such as line disorder during production operation, this switch can be pressed to stop the machine in an emergency.

5. Place the buffer swing rod at the low point. (When leaving the low detection position, the machine will be judged to be disconnected and shut down at the low position)

6. Set the startup speed of China twisting machine manufacturer, set 50-100m first, and then slowly increase the speed to high speed after starting the machine.

7. After starting slowly, observe that all parts operate normally before accelerating.

8. Since there is no actual winding operation, the winding shaft cannot control the speed. It will reach high speed in a short time or slow down to a standstill, depending on the position of the buffer swing rod.

9. Check whether the linear speed, slip and meters displayed on the display screen of China twisting machine manufacturer are normal.

10. The machine will stop after running for about 1 hour without load.

china twisting machine manufacturer https://www.newheli.com/Machinery-Product