A leaky tap is often caused by the O-ring or the washer fastened to the jumper valve.If the tap leaks, you often need to replace the washer adjacent to the jumper valve. However, a worn-out or damaged O-ring is most likely to blame if water leaks from the tap while it is in use.

It is not too difficult to disassemble a tap and replace the washer or O-ring to repair a leaky tap, even if you have never fixed a tap before. These are the measures you should take to repair a leaky bathroom tap. The Plumber Abbotsbury services from Fix N Flow offers the best suggestions for the issue.

The equipment needed to repair a dripping tap

A spanner or wrench, ideally an adjustable one that can be used on nuts of different sizes, is necessary to fix a leaky tap. If your tap quickly gets stuck, a pair of pliers could also be useful. You'll also need a new washer or O-ring, so make sure the new one will fit by measuring the one you're presently using.

Are DIY Kits Enough?

As an alternative, you may purchase a repair kit that, ideally, comes with a tap and everything else you need to fix it.Does the hot water tap drip or leak when you turn it on? The first step is to determine the problem's underlying cause. You may need to change the washer near to the jumper valve if the tap leaks even after you've turned it off. The O-ring has to be changed if water is dripping from the base or stem of the tap. You may choose to perform both concurrently if you can't decide between the two possibilities!

What the Experienced Plumbers Suggests

The water mains need to be quickly shut off. Once the supply has been cut off, you may use the tap to drain any leftover water in the pipes.The screw or button holding the handle in place has to be removed first. As a result, the handle will separate from the stem, making removal simpler.

Remove the skirt or cover plate at this time. In certain circumstances, the screw may come out without needing to be undone. You may require pliers to remove it if it's stuck anywhere due to adhesive.The jumper valve could be located below the stem. Replace it with a new washer from the hardware store after taking it apart.Get a hold of the shaft and, if the O-ring is impeding your efforts, either remove it entirely or cut it. Simply roll a new O-ring over the stem until it is positioned in the same spot as the old one to replace an O-ring.

Conclusion

The Plumber Bonnyrigg service simply screws the stem back into the base to reassemble, replacing the jumper valve and washer. They use the same technique to assemble the remaining parts. By turning the tap on, they check its operation. And then it’s done. So if you still are unsure of how to fix a leaky tap, don't worry. If you give us a call, we'll send one of our plumbers right away to your area to assist you.